LUXON 4-POST RUBBER ISOLATED 1 1/8" BAR MOUNTS STARK VARG CONE INTERFACE

Luxon lightweight 4-post bar mounts eliminate twisting due to small crashes and tip-overs without sacrificing vibration absorption like a solid mount would. Four sets of bushings absorb hard hits and track roughness without compromising steering precision. Three different rubber bushing sets (soft, medium, and firm) are included to fine tune the feel.

Luxon Stark mounts are compatible (and require) the stock phone holder. The mounts are the stock height of 25mm (bottom of bar to top of triple clamp) and stock offset (7mm of bar position change when flipping the mounts around).

Luxon bar mounts have the same bar position geometry as stock Stark Varg (height and offset). Handlebar size is available in standard 1 1/8" size only.

Kit Includes:

• Rubber isolated lower bar mounts
• Rubber bushings
• High-strength steel mount bolts
• Anti-seize
• Instruction manual

(Re-use your stock top clamp/phone mount and bolts).

Three different hardness levels of rubber bushings are included at no additional cost. Soft (green) is for lighter riders, vet riders, or those with wrist injuries. Medium (yellow) is recommended for most off-road and motocross use, and hard (red) is recommended for aggressive motocross use and faster riders. 

Bushings will "break in" on the first ride and become a little softer than when first installed. Like all rubber bushings, these are wear items and will eventually break down and need replacing. Softer bushings will need to be replaced more often than harder bushings. Replacement bushings are available here.

Luxon 1 1/8" bar mounts fit standard 1 1/8" (28.6 mm) handlebars (sometimes called fatbars). Luxon do not offer bar mounts to fit the old 7/8" size handlebars. Other aftermarket companies offer adapter bushings to fit the 7/8" bar diameter in standard 1 1/8" mounts if necessary.

WEIGHT (excluding top mount and pinch bolts) 321 g, 0.71 lbs
STOCK WEIGHT (excluding top mount and pinch bolts) 235 g, 0.52 lbs

STARK

• VARG 2023-2025 (both Motocross and Enduro models)

These bar mounts fit the Stark Varg and are intended to use the stock phone mount (top bar clamp) and pinch bolts. A Phone Delete option is available that includes pinch bolts and top clamps should you want to remove the Stark phone mount. NOTE: The Phone Delete option uses black bar clamps on the silver base as shown in the image.

The Stark Varg Cone interface is a tapered cone shaped hole on the top and bottom of the triple clamp (a cross section would look like an hour glass).

VIEW INSTALLATION INSTRUCTIONS HERE