LUXON GEN3 RUBBER ISOLATED 1 1/8" 4-POST BAR MOUNTS (FOR GEN3 TRIPLE CLAMPS)

Luxon lightweight 4-post bar mounts eliminate twisting due to small crashes and tip-overs without sacrificing vibration absorption like a solid mount would. Four sets of bushings absorb hard hits and track roughness without compromising steering precision. Three different rubber bushing sets (soft, medium, and firm) are included to fine tune the feel.

These mounts have a height of 21 mm (bottom of bar to top of triple clamp) and a 3.75 mm offset (7.5 mm of bar position change when flipping the mounts around). An optional spacer kit is available (allows 21 mm, 26 mm, 31 mm, and 36 mm heights).

Kit Includes:

• Rubber isolated lower bar mounts
• Rubber bushings
• Upper bar clamps
• High-strength steel mounting bolts
• High-strength steel clamp bolts
• Anti-seize
• Instruction manual.

Three different hardness levels of rubber bushings are included at no additional cost. Soft (green) is for lighter riders, vet riders, or those with wrist injuries. Medium (yellow) is recommended for most off-road and motocross use, and hard (red) is recommended for aggressive motocross use and faster riders. It is also possible to mix different hardness levels of top and bottom bushings (for example, medium uppers with hard lowers) for further tuning.

Bushings will "break in" on the first ride and become a little softer than when first installed. Like all rubber bushings, these are wear items and will eventually break down and need replacing. Softer bushings will need to be replaced more often than harder bushings. Replacement bushings are available here.

BAR CLAMP BOLTS - available in two options:

• High Strength Steel
• Grade 5 Titanium (optional upgrade)

SPECIFICATIONS

WEIGHT (1 1/8") 367 g, 0.81 lbs
WEIGHT (1 1/8") 347 g, 0.76 lbs (with ti bolts)
WEIGHT (36 MM) 399 g, 0.88 lbs
WEIGHT (36 MM) 379 g, 0.84 lbs (with ti bolts)
XTRIG PHDS WEIGHT (1 1/8") 506 g, 1.12 lbs

FITMENT:

M12 Direct Bolt-On Interface:

These bar mounts fit Luxon Gen3, Gen3 Pro and many Xtrig triple clamps (they DO NOT fit stock triple clamps or other aftermarket clamps). Luxon mounts fit most bikes without issue. In some cases, you may need to trim plastic brackets or relocate hour meters or accessories to allow clearance in the extreme mounting positions (for example: front hole, bars away from the rider). Always check for full clearance after installation and before riding.

Image: The M12 interface on a Luxon Gen3 triple clamp.

The M12 interface is a recessed slot on the top triple clamp, 26 mm wide, with three 12 mm threaded holes per side. The bar mounts sit in these slots and bolt directly to the triple clamp with an M12 bolt.

BAR SIZE:

Luxon 1 1/8" bar mounts fit standard 1 1/8" (28.6 mm) handlebars (sometimes called fatbars) and 36 mm bar mounts fit the Renthal FB36 bars (36 mm). These are NOT the same as fatbars, they have a much larger clamping diameter. If you're not sure, you almost certainly want the 1 1/8" bar size!

Luxon do not offer bar mounts to fit the 7/8" size handlebars. BRP and other aftermarket companies offer adapter bushings to fit the 7/8" bar diameter in standard 1 1/8" mounts if necessary.

VIEW INSTALLATION INSTRUCTIONS